Graco Edge II HVLP Quick Release Fluid Sets

Maximize your spraying performance with the Graco HVLP EDGE II HVLP Gun by using the correct needle & nozzle size for the material being sprayed. Graco Edge II Quick Release Fluid Sets are designed for quick changing on the job without the need for tools.

Quick Release Needle Design

• Change out needles from the front of the gun with just a click
• Easy to change, easy to clean with no tools needed
• Remove front air cap and nozzle
• Slide trigger lever to release needle
• Pull needle out

Quick Release Fluid Sets available for Graco Edge II Guns –

• Part No. 17P485         #2 Needle & Nozzle Set (0.8mm)
• Part No. 17P486         #3 Needle & Nozzle Set (1.3mm)
• Part No. 17P487         #4 Needle & Nozzle Set (1.8mm)
• Part No. 17P488         #5 Needle & Nozzle Set (2.2mm)
• Part No. 17P489         #6 Needle & Nozzle Set (2.5mm)
• Part No. 17P490         #7 Needle & Nozzle Set (2.8mm)

Choosing the correct needle & nozzle size for your Graco Edge II HVLP spray gun will ensure a perfect finish. Use the guide below to select the quick release fluid set applicable to the material being sprayed.

Note – HVLP turbines produce heat in the motor warming up the air supplied to the gun, you may need to use a slower drying thinner to compensate for the faster drying time.

AA Spray stock a full range of Graco HVLP guns, fluid sets, check valves, filters and hoses to suit all models of Graco HVLP Turbine Sprayers with fast delivery Australia wide.